Before Tony delivered our 1970 MGC GT, Jonn gave it a final checkover and made some minor repairs.
Here are his notes:
Remove car from Classic lounge. Carry out full Appraisal. Adjust bonnet secondary catch. Attend to offside rear axle strap. Rethread broken stud and fit new nut and washer and apply loctite. Grease all points. Fit split pin to nearside top suspension Taunton castlated nut. Remove wheels and clean and check brakes.
Check and inflate all tyres and knock up tight all wheels. Fit sticky back foam behind rear number plate and secure. Sort earth for nearside number plate light and test. Align and test washers. Cut back electronic ignition wires and crimp on terminals. . Secure fuel feed pipe at nearside chassis and air filter with p clips. Cut split carburettor overflow pipe. Join with small plastic fuel pipe and refit. Top up engine oil. Put Jack and hammer in boot.
Free off both track rods. Lower to floor and drive back and forth to settle suspension. Check tracking. Toe out 2 degrees as expected due to tyre wear. Adjust to 0 degrees , 30 minutes toe out and lock up track rods. Carry out road test, ok. Carry out pdi.
