Exhaust And PDI

Picture of By Rob Harvey
By Rob Harvey

Jonn has been completing his work on our 1972 Morgan 4/4.

He has: Fit new exhaust tailpipe. Mock fit and align mount. Mark position and remove. Centre pipe larger bore. Cut slots in end of centre pipe and refit tailpipe. Clamp up centre joint and check. Remove and add sealer to pipe and refit. Secure mount at rear and tighten clamp. Run and test, ok. Finish pdi.

Carry out road test. All seems ok when warmed up. Check anti freeze, zero. Drain some coolant and top up with anti freeze. Run and test.

Share this post
Enjoyed this article by Rob Harvey?
Email Rob Harvey