classic triumph suffolk

Repairs on our 1960 Triumph TR3A

Our technician Jon has been busy working on getting our 1960 Triumph TR3A back up to scratch here at the Bridge Classic Cars HQ. To Begin with, Jon checked the roof on the classic sports car to make sure it fit and there was no damage along with checking the side screens. With the side screens, he noticed that the drivers side screen would not fit correctly due to the mirror on the A pillar.

Next up, Jon could get the car up onto the ramp to check for any leaks over night. The next morning, he noted a few small drops of oil which were traced back to the sump and the lower bolts in the front cover. So Jon cleaned down the area and began removing the bolts from the areas to then get them properly cleaned ready to be resealed and cured. After that he could move onto the next job on the list – the exhaust.

Upon inspection Jon noted that the exhaust was too short for the car. So, he began the journey of lengthening the pipework to get it to fit correctly under the car and to fit the correct rear silencer/section. He began by carefully tack welding a new piece of stainless tube into place before removing the whole system from the car for our fabricator Clinton to completely weld up. While that was being done, Jon carefully ground a new bonnet key for the car and then once the exhaust was back, fit everything back up to the car ahead of its road tests. During the tests, Jon found the carpet section behind the pedals moved, so he glued the section back down before leaving it to cure.

All Sorted – Mechanical Work on the 1955 Triumph TR2

The Bridge Classic Cars workshop have finished up the mechanical work on the 1955 Triumph TR2 which is in with us.

To begin with, the team worked on getting to the bottom of a concern from the customer of the car pulling to one side under braking. The team found that the wheel cylinders were leaking quite badly and on one side no longer allowed the shoes to make proper contact with the drums. A new set was ordered along with a complete set of front brakes shoes. Once installed, the team could readjust the brakes and retest. This sorted out the pulling issue on the classic Triumph. At the same time the team adjusted the rear brakes to spec

While under the car, the team discovered several ball joint rubbers had split quite badly. In total, 5 were replaced on the front suspension including the top ball joints and track rod ends.

In the engine bay, the team discovered a leak from the radiator of the TR2. The radiator was removed from the car, having to remove the front fascia from the car to get access. This was sent of to a specialist to be refurbished for the car. Whilst in the engine bay, it was discovered to have some debris (what appeared to be leaves/flowers) inside the sight glass of the carburettor which acts also as a filter. The team cleaned out the fuel lines properly and inspected the tank to make sure everything was all ok and replaced a split in the brake servo pipe.

Whilst awaiting the radiator to come back from repairs, our technician Jon fixed an issue with the seat runner the customer had mentioned. Jon repaired the seat runner the best he could.

Once the radiator returned, the team could get it back into the front of the classic sports car. With the radiator in place, the team could also sort out some wiring which had to be cut for the front fascia to be removed.

After everything was back in place and levels topped up and checked, it was given the all-clear to go back to the customer.

Tucked Away – 1973 Triumph TR6 at Home in its Garage

The 1973 Triumph TR6 which was built by Bridge Classic Cars for our friend Stephen has been moved into its own secure garage at home in France.

Stephen recently took delivery of both the 1973 Triumph TR6 and the 1973 Jaguar E-Type V12 Roadster, Fern Grey. Both of these cars now live in France with their owner in their own separate garages!