classic ford specialist uk

Stripped Back – Stripping the Carburettor of the 1986 Ford Capri

The restoration technicians at Bridge Classic Cars have stripped down the carburettor of the 1986 Ford Capri to get the classic Ford running just right.

Our technician Jon completely dismantled the aftermarket carburettor on the Capri due to the car running slightly off. He carefully and methodically cleaned out every port and duct on the carburettor to remove any form of sediment or dirt which may have built up over time inside the part.

With the carburettor taken apart, Jon could inspect all the necessary pieces before putting it back together with a clean bill of health and get it back onto the car. Once back on the car, Jon had to perform a small wiring repair before setting the carburettor up to get the Capri running perfectly.

Moving Forward – Work on the 1986 Ford Capri Wiring, Brakes, Suspension and Parts

The team in the Bridge Classic Cars workshop have been working on the 1986 Ford Capri to get everything working exactly as it should.

First, our technician Jon continued to work on the wiring under the dash of the classic Ford. He found a few repairs to the original wiring which were causing the original radio to not work correctly. So, with the repairs done to the harness and cleaning up unneeded wires, the original radio was now working just right.

Next up, he fitted the freshly repainted and refurbished engine bay pieces into the car. Several shrouds, the rocker cover and pipes were painted by our in-house paint shop for the Capri to give the engine bay a new fresh and clean look.

Finally, work could begin under the Capri. With the car up in the air, Jon had access to the suspension and brakes. First up was replacing the anti-roll bar bushes. These had perished over time and were allowing too much flex, so a new set of replacements were ordered and installed underneath. Whilst in the air, Jon could begin looking into an issue with the rear brakes.

Our other technicians on the car’s initial inspection noted a slight brake bind on the rear. So, Jon looked into the issue and found the rear drums were in need of a rebuild. Along with that, he replaced the hardline that runs across the rear axle to the new wheel cylinders. Then, after bleeding the brakes he reported that all was now OK and no more brake bind.

Now, it’s time to move on to getting the 1.6 litre 4-cylinder running properly.

This Just In – 1986 Ford Capri Laser

The latest arrival into the Bridge Classic Cars workshop at our Suffolk HQ is this 1986 Ford Capri Laser.

This car is currently undergoing its assessment by the various in-house teams to get this iconic classic Ford into the best shape possible.

Keep a lookout here on the Bridge Classic Cars news page for more updates on the 1986 Ford Capri.