By Craig Ranson
The workshop at Bridge Classic Cars have been working on finishing up the service and carburettor rebuild on the 1957 MG A Roadster.
To start with, the team have installed the jet tube into the rear carburettor and installed the whole unit back onto the engine. As part of this, the team have also cleaned out and oil the K&N air filters to give the 1.8-litre 4-cylinder the best airflow and as part of its service scheduling.
After this was done and the carburettors were checked for leaks, which have been reported to working perfectly, the team could move on to adjusting the tappets.
The tappets and valve train were all inspected and adjusted to the correct specs before the rocker cover (complete with new gasket) was fit back onto the engine.
Share this post
Enjoyed this article by Craig Ranson?
