1969 Jaguar E-Type Roadster

An E-Type Arrives

Tony recently collected our 1969 Jaguar E-Type Roadster. When it arrived, James carried out a service/appraisal. He put the battery on charge and carried out

Read More ยป

A New Battery

After replacing the battery on our 1969 Jaguar E-Type, it was safely delivered back home to its owner in Norfolk.

An E-Type Arrives

Tony recently collected our 1969 Jaguar E-Type Roadster.

When it arrived, James carried out a service/appraisal. He put the battery on charge and carried out a full inspection of the car. All the brakes and tyres were checked, including the pressure of the spare. The brakes were all good so James removed the carpet and inspected the plug to check the gear oil. This was ok, as was the rear diff oil.

James noticed slight oil leaks from the engine, high up and the rocker covers are showing signs of weeping. He checked all of the lights, washers, wipers, and signals. The horn was not working.

There was a small drop of oil on the rear diff and gearbox. The spare tyre was flat but the tyre and wheel rim were new with no visible puncture.

James went on to grease the rear suspension and drive shafts. The offside rear outer suspension arm was cracked slightly and the grease nipple was loose. The exhaust front pipe was slightly damaged on the lower edge which James thinks could be due to height.

The oil and filter were drained/replaced along with the air filter and spark plugs. Then James investigated the horn not working. The relay that controls the horn was checked, and the horns worked when powered separately. The earth from the steering wheel switch was checked as ok, but there was a live feed missing from the relay. This was traced back to the fuse box, there was no continuity through the fuse despite it looking to be in good condition. A replacement fuse was fitted, and the horns worked, the old fuse was found to be broken internally despite its external appearance.

He then moved on to the oil leak. Both rocker covers were removed, along with the camshaft end plates (these can leak too). All residue of excess sealant was removed from the old seals and mating areas, and then the correct sealant was added to the cylinder heads and rocker covers. New gaskets were fitted, the the covers were installed with new copper sealing washers and tightened. The oil residue was cleaned from the engine, and then new oil was added and the car was run up to recheck for leaks from the rocker covers area and new oil filter.

All maintenance points were greased and levels checked and topped up, tyres checked for pressure and depth, and lights and wiper operation confirmed ahead of an MOT test. The battery was charged but appears low still, so replacement is recommended. Visual inspection of brake and suspension components was all ok.